Written Instructions

Step 1: Unpack
- Pick a place that you will leave your device to cure for 24-48 hours after you apply the coating. Somewhere it will not be bumped or touched.
- Get a bowl of water, you’ll need it in step 4.
- Unpack the kit and set up your work surface. You may want to lay down a protective sheet of paper.
- Keep the box close by, you’ll use this to prop up your device to cure.

Step 2: Clean
- Put on the rubber gloves
- Open the alcohol wipe and wring it out a bit, it is juicy.
- Thoroughly wipe your device, until it is clean
- Dry with one side of one of the grey cloths.

Step 3: Apply
- Fold the thin applicator cloth into quarters
- Open the bottle, and apply 5-10 drops to the cloth
- Wipe the cloth onto your device, one panel at a time (e.g. the front)
- It will look streaky and hazy. Don’t worry.
- Make sure there are no dry spots. Reapply 5-10 drops and wipe the back of the device. - Coat the entire device, including the screen.
- Keep coating off any electrical contacts, speakers, or ports.

Step 4: Level
- Let your device sit for 2-3 minutes undisturbed, while you proceed to the next sub step.
- Take your bowl of water, and submerge the grey towel from step 2.
- Throughly wring out the towel. You want it to be damp, not wet or dripping.
- After 2-3 minutes, take your damp cloth, and gently wipe down your device, all over.

Step 5: Buff
- Take the dry grey cloth and buff your device, all over.
- The haze and streaks should readily disappear.

Step 6: Cure
- Set your device in the safe spot you picked in step 1, lean it up against the PWRUP   Ceramic Box.
- Don’t touch your device for 24-48 hours (If it is cool in your room, do 48hrs).
- You’re done! Congrats on your PWRUP!